Search
Filters

RockJock 70 - Jeep JK Rear Full Floating Crate Axle (5/6 Lug)

JK RockJock® 70 Full Floating Rearend Unit (35 Spline, 5 Lug, Incl. Brake Backing Plates, Bolt-In)
SKU: JK-RJ70R1
Vendor: Currie
*

Width Between Wheel Mounting Surfaces (WBWMS)

*
*
*
*
*
*
*
*
$5,049.95

The RockJock® 70 high pinion rearend assembly for the 2007 and up Jeep JK includes the complete housing with the 65-45-12 ductile iron housing center, AR400 heat treated bottom skid plate allowing the axle to slide over rocks easily, 3 1/2" x .375" wall d.o.m. steel tubes, heavy duty cast iron red Currie diff cover, forged steel 1350 yoke and our billet steel full floating housing ends that allow for all of the factory JK disc brake hardware and ABS and ESP sensors to bolt back on. All new heavy duty Currie Jeep JK suspension brackets are mounted and feature multiple control arm mounting holes, multiple trac bar mounting holes and adjustable shock mounting holes. Also included are the Currie 4340 chromoly 35 spline full floating axle shafts, billet steel full floating hubs with 5 on 5 1/2" wheel bolt pattern, 1/2" wheel studs and ABS tone rings installed, factory disc brake backing plates that are modified for this application and drive flange kit. All hub & axle bearings, seals and hardware is included. All you need to complete this unit is a high pinion 70 ring and pinion gear set, Dana 70 35 spline carrier of your choice, a center section bearing & set up kit and labor to set it up! Your JK's stock rotors and calipers are reused! NOTES: Rotors will need to have the wheel bolt pattern redrilled and the center hub hole bored to clear the floating hubs. This unit is 66" wide.

The RockJock® 70 high pinion rearend assembly for the 2007 and up Jeep JK includes the complete housing with the 65-45-12 ductile iron housing center, AR400 heat treated bottom skid plate allowing the axle to slide over rocks easily, 3 1/2" x .375" wall d.o.m. steel tubes, heavy duty cast iron red Currie diff cover, forged steel 1350 yoke and our billet steel full floating housing ends that allow for all of the factory JK disc brake hardware and ABS and ESP sensors to bolt back on. All new heavy duty Currie Jeep JK suspension brackets are mounted and feature multiple control arm mounting holes, multiple trac bar mounting holes and adjustable shock mounting holes. Also included are the Currie 4340 chromoly 35 spline full floating axle shafts, billet steel full floating hubs with 5 on 5 1/2" wheel bolt pattern, 1/2" wheel studs and ABS tone rings installed, factory disc brake backing plates that are modified for this application and drive flange kit. All hub & axle bearings, seals and hardware is included. All you need to complete this unit is a high pinion 70 ring and pinion gear set, Dana 70 35 spline carrier of your choice, a center section bearing & set up kit and labor to set it up! Your JK's stock rotors and calipers are reused! NOTES: Rotors will need to have the wheel bolt pattern redrilled and the center hub hole bored to clear the floating hubs. This unit is 66" wide.